Flag ITA dark   Flag ENG dark

Light control

ico luceAll our products for the illumination installations.

 

 

 

Livestock equipment

 

XP69 frontale th

XP69 0-10V Dimmable light control

Controls ascending and descending ramps and the stand by timing at minimum value and is compatible with all dimmable lights 0/10v.

 read more

 
 
pan HP61

HP68 Lights sequence

Allows  to operate ceiling dual lamp with a lamp in regulation 0-10V (incandescent) and a lamp On-Off (neon).

 read more

 

pan HP61

HP69 0-10V light control

Allows to operate an output in 0-10V regulation with an ascending ramp ......

 read more

 

xfarm frontale th

Xfarm (livestock controller)

Performs climate and feeding control.

Lights can control by On/off output and with dawn/sunset 0-10V output.

read more

 

qfarm frontale th

Qfarm (livestock controller)

Performs climate and feeding control.

Can control light with control up to 8 lights (by On / off output and with dawn / sunset 0-10V output), can also control the opening and closing of hens nests.

read more

 


Green houses

  

pan HP31

HP31 Luminosity controller

Permits to action the control of shadow protections in a greenhouse.

 read more

 

pan HP60

HP34 Temperature-luminosity controller

Permits to control heating/cooling with two different day/night sets.

 read more

 

box lp11

LP line

Permits to action the control of shadow protections in a greenhouse.
This actioning is realized in daily phase, with the opening control on the ground of the programmed luminosity (express in K.lux) and obtained from its sensor, while in nightly phase (with programmable times on the daily commutator situated inside the unit) the protections are completely extended to mantain the warm inside. The actioning of the protection is of a modulated type, with opening at programmable breaks of the dark protections.
The connection at the unit to action is very easy: it's enough to connect the motor to action and the security's limit-switches (both these two items are not of our production), moreover it is possible to connect the intermediate limit-switch that permits to limit the maximum closing of the protections.
The unit comes equipped with all relevant power components (contactors, automatic switch, etc.) mounted in an IP55 plastic box, completed of a HP31 control microcomputer module and of a selector that permits a full manual control of each gear motor, and intermediate limit-switch selector.
All components that the operator can use are mounted on the frontal unit (microcomputer module, automatic switch of single gear-motor, , automatic / manual selectors of single gear-motor, general switch) to permit to operate immediately with the unit.